Hampshire Damp Proofers
Positive Input Ventilation in Ringwood, Hampshire

Damp proofing in Ringwood

Positive Input Ventilation in Ringwood

Positive input ventilation (PIV) in Ringwood. A PIV unit gently pushes filtered fresh air through the home, keeping humidity down across the whole house rather than one room.

Get a quote in Ringwood

A free, no-obligation survey and a written quote.

Free, no-obligation surveys
Fixed written quotes
Cause treated, not the patch
Local, Hampshire-based

Positive Input Ventilation

Positive Input Ventilation across Ringwood

Positive input ventilation (PIV) in Ringwood. A PIV unit gently pushes filtered fresh air through the home, keeping humidity down across the whole house rather than one room.

It is a quiet, low-cost answer to condensation and mould in Ringwood homes, and we set it up to run efficiently and explain what it costs to run.

Positive Input Ventilation in Ringwood
Green mould and algae from persistent condensation

What’s included

What positive input ventilation in Ringwood covers

Every quote varies depending on the property and what the job needs, but here is what a typical positive input ventilation job in Ringwood covers from start to finish.

  • An assessment of how the property breathes
  • Extractor fans for kitchens and bathrooms
  • Positive input ventilation for whole-home control
  • Humidity-sensing controls where suitable
  • Advice on running costs and daily use

How we do it

Positive Input Ventilation in Ringwood: the process

  1. Step 01

    Assess

    We look at where moisture is made and where it collects.

  2. Step 02

    Specify

    We recommend the extraction or whole-home system that suits the home.

  3. Step 03

    Install

    Units are fitted neatly and set up to run efficiently.

  4. Step 04

    Explain

    We show you how it works and what it costs to run.

Positive input ventilation in Ringwood

Positive input ventilation is the simplest lasting answer to condensation and the mould that follows it. Rather than extracting damp air room by room, it gently dilutes it across the whole house. It suits some properties very well and others not at all, so it is worth understanding before you buy one.

How a positive input ventilation system works

A positive input ventilation system is a single low-wattage fan unit, normally mounted in the loft, drawing air through a filter and introducing it into the home at a gentle, continuous rate, usually through a diffuser in the landing ceiling.

That slight positive pressure pushes stale, humid air out through trickle vents, gaps and background leakage. Instead of removing moisture at source the way an extractor does, it keeps the humidity of the whole house below the level at which condensation forms on cold surfaces. Better units sense humidity and temperature and vary the rate accordingly.

Condensation on a window in a Ringwood home before PIV is fitted

Positive input ventilation pros and cons

The advantages are real. It is inexpensive to install next to mechanical ventilation with heat recovery, cheap to run, needs almost no maintenance beyond an occasional filter, works across the whole property rather than one room, and deals with condensation without asking anyone to change how they live.

The drawbacks are equally real and less often mentioned. It introduces outside air, so in cold weather a basic unit can make a landing feel draughty unless it has a heater or tempers the incoming air. It relies on air being able to leave, so a very airtight home, or one with every trickle vent taped shut, will not work well. It does nothing for rising or penetrating damp, and it will not fix mould caused by a leak. In a flat with no loft a unit is wall-mounted instead, which suits some layouts and not others.

Mould in a cold corner that positive input ventilation prevents

Is PIV right for your Ringwood home?

PIV suits houses with a loft, general condensation across several rooms, and mould appearing in the usual cold spots. It is a poor answer where the moisture has one obvious source, such as a bathroom with no extractor or a tumble dryer venting indoors, because dealing with that directly costs less and works better.

We survey the Ringwood property, take humidity and surface temperature readings and tell you honestly which it is. Sometimes the right recommendation is a decent extractor fan and better trickle ventilation rather than a PIV unit at all.

Assessing whether PIV suits a Ringwood property

Positive input ventilation cost in Ringwood

Installation is usually straightforward: the unit, a ceiling diffuser, a power supply and commissioning, typically completed within a few hours. Running costs are low, often only a few pounds a year, because the fan draws very little power and most units modulate rather than running flat out.

We quote each Ringwood installation in writing after the survey, setting out the unit we recommend and why it suits your property.

Survey and written quote for PIV installation in Ringwood

PIV installers near you in Ringwood

We cover BH24 and the villages around Ringwood, including Bisterne Close, Blashford, Ashley Heath, Verwood, Hampreston and Colehill. As damp specialists rather than a ventilation-only firm, we will tell you when a positive input ventilation system is not the right fix for the problem you have.

Book a free survey and we will measure the humidity before recommending anything.

Hampshire Damp Proofers fitting a PIV unit locally

Book a free positive input ventilation survey in Ringwood

Tell us what you have noticed and we will come out, find the cause and provide you with a written quote with no obligation.

The quote

Positive Input Ventilation in Ringwood costs

Every property is different, so we quote each Ringwood job on its own after a free survey rather than off a description. These are the things that move the figure, and we set it all out in writing before any work starts. The visit is free.

  • Whether you need single fans or a whole-home system
  • The number of rooms being ventilated
  • The type of controls fitted
  • How the units run and where they vent

Common questions

Positive Input Ventilation in Ringwood: your questions

What is positive input ventilation?

It is a quiet unit, usually in the loft, that gently pushes filtered fresh air through the Ringwood home, keeping humidity down across the whole house.

Does a PIV unit make the house feel cold?

It can if it is badly specified. A PIV unit introduces filtered outside air, so in winter a basic unit can make a landing feel draughty. Units with a built-in heater or temperature control temper the incoming air and largely remove the problem, and we specify for the Ringwood property rather than fitting the same unit everywhere.

Are the fans noisy or expensive to run?

Modern units are quiet and use very little power, and many run only when humidity rises. We tell you the running costs before you decide.

Will ventilation on its own cure my mould?

If the damp is condensation, controlling the moist air is the real fix. We treat the existing mould first, then ventilate so it does not return.

Where does a PIV unit go?

Usually in the loft, with a discreet ceiling diffuser on the landing. In a flat without a loft we fit a wall-mounted unit instead.

How much does ventilation cost to run?

Very little. A PIV unit uses about as much power as a low-energy bulb, and humidity-controlled fans only run when they are needed. We provide you with the running costs before you decide.

Get a quote in Ringwood

A free, no-obligation survey and a written quote.

Looking for a service other than Positive Input Ventilation in Ringwood?

We cover the full range of damp and timber work for Ringwood homes:

Not in Ringwood? Still looking for Positive Input Ventilation near you?

We provide positive input ventilation across Hampshire, including:

We also provide positive input ventilation to: Bisterne Close, Blashford, Ashley Heath, Verwood, Hampreston, Colehill

Call now Get a quote